David, I looked again at your modeling software. This models for flat KSS panels up to the bows. I presume the bows end up to be the most restrictive. Rob advocates flat panels until short of the bows where the bows are carved to shape out of foam. If the modeling parameters would leave out the bows for a feet or two would this not allow more degrees of freedom for curves in the flat panels for the main part of the hulls given that compound curves, if necessary, could be carved in the bows themselves?
__._,_.___
Posted by: lucjdekeyser@telenet.be
| Reply via web post | • | Reply to sender | • | Reply to group | • | Start a new topic | • | Messages in this topic (8) |
.