G'day,
I won't be home tomorrow, or much of the weekend. Or mornings next
week. School holiday stuff.
It is a different technique to the first hull which had no compund
curves. The technique was definitely a success, although I completely
ballsed up the second piece when I did not line the frames up
properly. I then ballsed up the first end as well trying to make them
match.
This one will havecompound curve, below the waterline. The next one,
maybe above it as well.
regards,
Rob
On Thu, Apr 17, 2008 at 12:20 PM, Doug Haines <doha720@yahoo.
>
>
>
>
>
>
> Hi Rob,
>
> Thinking of dropping in tommorrow.
> See what you are planning to try.
> Is this same as the solitarry hull you made in the garage there?
> Was that considered a success?
>
> Doug
>
> Rob Denney <harryproa@gmail.
>
>
> G'day,
>
> Not bad at all. Polycore will not need triax, but there will be some
> uni along the deck edges and keel of the lee hull. The Polycore will
> be quicker, if the new technique works. Will know that for sure after
> this weekend. Drop round next week (scall first, I am not here most
> days) and have a look.
>
> Pity about the weather for your cruise, but any sailing is better than none.
>
> regards,
>
> Rob
>
> On Wed, Apr 16, 2008 at 5:54 PM, Doug Haines <doha720@yahoo.
> >
> >
> >
> >
> >
> >
> > G;day Rob,
> >
> > At highpoint timbers to check price - 8mm x 40mm is $1.21 per metre.
> >
> > This is not too much higher than about 4-5 years ago. So is there likely a
> > cost benefit for kiri or nor kiri? Understand weihgt is more than polycore
> -
> > would need tri-axial cloth though for hull if with polycore.
> >
> > Lost wind on sail, got fed up so turned back early. No surf on beach as
> goes
> > from 2-3 metres up to the shore so no breakers. Coarser beach with some
> > shells, and 4WDs.
> >
> > Doug
> >
> > Rob Denney <harryproa@gmail.
> >
> >
> > On Tue, Apr 15, 2008 at 9:56 AM, Doug Haines <doha720@yahoo.
> > >
> > > Hi,
> > >
> > > Looking at a Harrigami WW, with 13,14m Harry LW. How acccom in this -
> two
> > > big singles OK instead of two doubles. seating cockpit 4 instead of 6 is
> > > good too.
> > > Also how about a schooner easy rig. Thinner mainsails so to fit the jib
> > boom
> > > of aft mast and main boom of forward mast in the central space in line
> > with
> > > each other for free swinging 360 degrees unimpeeded. With e the extended
> > LW
> > > but there should be enough space without putting masts too near the
> ends,
> > or
> > > also keeping thebeams linked to the masts.
> > > I don't want to miss the advantages of either type of rig - so have
> both!
> > >
> > > Doug.
> > >
> > > PS had a cruise down coast 2 nights, 3 days, saw penguin , albatross,
> > 4WD's
> > > on beach - like a highway dwwn there.
> > > Changed mind about rudders needing to kick up - breaking a pin would
> > > probably do.
> > >
> > >
> > > Alos rob - how much is harrigami plans or would that be a harry plan
> set?
> >
> > > G'day,
> >
> > No problem putting smaller ww hulls on bigger lw hulls. Easy enough
> > to change the accommodation, although harrigami had cockpit for 4 and
> > small doubles/big singles so not much to change. Price is $3,000 less
> > the price of your El plans, plus gst. Great that you are doing some
> > sailing, wish I was.. Did you sleep onboard? At anchor or on the
> > beach? How far south did you go?
> >
> > Two easy rigs are probably more hassle than they are worth, but you
> > are welcome to try. By the way, I am ordering some Polycore next
> > week. If you want to share the freight, let me know.
> >
> > regards,
> >
> > Rob
> >
> >
> >
> > ____________
> > Yahoo! for Good helps you make a difference
>
>
>
> ____________
> Yahoo! for Good helps you make a difference
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch format to Traditional
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe